Before I go for my walk today I’m going to make a quick post with the pictures of how the steering arms fit after a little filing on the register bits. This first pic is the one I did last night after finishing my walk. Note that the bits fit flat against the machined spots they are supposed to fit flat against on both sides now.
And this is the one I didn’t do yet. Notice that the peg part of the arm sits on top of the machined hole in the spindle. There is only a few thousandths of an inch interference there but it is enough to make the part unusable without modification.
The difference is about 3 hours of work, 2 of actual filing and another hour of letting my hand rest so I could control the file better. I have to admit the ravages of age are catching up to me. I used to be able to rough shape bike fenders by pinching them with my fingers, now I have to take frequent breaks just lightly using hand tools. And this is the fun bit for me, the tedious fiddly bits that nobody will see unless they know where to look and what to look for.
Now that that’s done I’m going to get dressed for outside and go for my walk. My books on how to control the EFI on the donor engine came today so I have reading materials that have to be read soon, and the bike pump is due in tomorrow so I can cover more territory out hunting check-ins on my phone game, and get exercise without killing my foot.
Billed @€0.02, Opus the Unkillable