Spent a lot of time doing research and saving pictures

Well, after my walk and reading e-mails I spent a lot of time reading from this archive where a dude in the UK is swapping a 3.3 into a Neon. Where it works for me is externally the 3.3 and the 3.8 are identical. What makes this particular swap helpful for me is the dude was obsessive about documenting the build with photographs. So I have 4 really good views, one of each side of the engine/transmission assembly, that can be used to help plan the back half of the Mid-Bucket.

This is what they look like coming out of the donor vehicle.From the left side showing the transmission mount.

Back side showing the mount next to the block, hard to see.

right front 3/4 view, front mount at the bottom of the engine, right mount under the alternator.

The right side showing the snake pit of the FEAD.

Left rear 3/4 view showing the rear mount much better.

OK, it looks like the front and rear mounts are going to go on the tube from the center of the rear hoop to the watt’s link behind the engine, and the left and right mounts will be connected to the frame by tubes running from the rear suspension shock mounts and the outside lower corner of the rear roll hoop. I need to figure out one more way to brace those mounts as they look to be weak in the vertical direction on the frame side, engine side looks fine if a bit heavy. The front and rear mounts are fine vertically but will need bracing left to right and back and forth. I seriously don’t want the engine hitting me in the back if I hit something from the front, so the mounts will be very strong to prevent that from happening. The front mount will be very low on the frame and it looks like just making the mounting plates to the frame heavy enough will do that if I brace that mount against the rear hoop as well as the tube running down the center of the frame. I’m half tempted to just make the mounts from plate stock and leave the rubber bits out so I can get a massage while I’m driving. 😈 But I will probably use one of these at each mount (or two kits). I’m extremely tempted to mount the front cushion at 45° to help keep the engine off my back in a wreck.

And I’m out of words after spending too much time researching this.

Billed @€0.02, Opus the fat but Unkillable

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s