I’m melting, melting, what a world…

Heat indexes have been off the charts lately, from what I can tell. I haven’t been able to go for my walks so I have been spending most of the time indoors and hardly check the weather, but it’s 86°F in my office as I type this with the AC going. So it can’t be anything but hot outside. But just FYI my phone says it is currently 98°F outside. At 1855. So by deduction it must have been over 100 at some point today, say like between 1400 and 1500. ETA the 2200 news weather report had a 100° high temperature. And the urban heat island effect keeps the nighttime temperatures up, too. And this is where today’s headline came from YouTube

I’m not happy with the way the floor came out for two reasons. Number one is I forgot to include the front support for the front fenders, and 2) I made the rear cutouts too wide, as shown in the pictures. Seriously I left enough room for a 16″ wide tire and the widest race tire I have been looking at seriously was 14″ with the street tires in the 12″ range. And I have plenty of raw stock for the floor, finally. So the floor will get a do-over. And that’s why those 9″ wide tires in the pictures looked so lost in there. Even the 10″ wide tires for the Mini Sprint-T would have been swallowed up.

While I am on the subject of the TGS2 I have been looking at a pull-rod spring instead of direct mounted springs for 2 reasons. One reason is I can change the spring rate just by changing 2 bolts, either a little or a lot, The second reason is the unsprung part of the pull-rod is much less than the direct mount spring because the entire spring and shock are moving with the car. Yes they move with the axle but they are entirely supported by the frame so they are sprung weight. The bellcrank and mount add a couple of pounds but it is all sprung weight. But the primary reason to go with the pull-rod springing is adjustability, I can change spring rate and ride height in just a few seconds and swapping a different length pull-rod is much cheaper than swapping different shocks and springs. Literally a dollars to donuts comparison, I can buy or make a custom pull-rod for about the price of a dozen donuts where a spring and shock absorber are $200-300 assembled. With my budget this is a cost-benefit ratio I can most definitely live with.

And I need to take a shower and hit the hay.

Advertisements

3 responses to “I’m melting, melting, what a world…

  1. Where are you? It’s been ridiculously hot in Georgia as well.

    Like

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s