But I also feel like I owe you a post. It’s not your fault my depression is “Should I get out of bed?” level or that I really don’t have much to write about. But I feel like you should know I’m not suicidal or anything like that, I just barely have the spoons to function.
I did do something that contributes to my functionality. I bought the epoxy that I need to repair my Cossie Mug that I got from Hoonigans that Mrs. the Poet broke after I only had one cup of tea from it.
The product I bought is a food-safe epoxy resin system, specified for repairing ceramics and protecting wooden vessels from food or hot beverages. It is supposed to be food safe when cured, but highly toxic before curing meaning I have to get nitrile gloves before I use the product. That means a trip to Harbor Freight because I forgot to get some in my Amazon order. Yeah, I forgot something, what else is new?
Seriously I’m strongly looking forward to getting this mug functional once more. I would show the “stainless” cup I’m getting my nightly cuppa from, but as it is a deep, deep, brown I don’t think that would be appropriate. And that’s just from drinking tea out of it. Can you imagine how it and my other mugs would look if I couldn’t run them through the dishwasher after coffee with milk and sugar?
On another topic than my crusty tea mug, I have been redesigning the frame for the Sprint-T so that I can haul my decrepit body in and out of it while still keeping it torsionally stiff. Basically I’m eliminating the top of the front hoop so I can get in and out of the car. Or I could just move the diagonal braces to under the top lip of the body and have a bar to park my butt on while I swing my legs in and out while keeping the head protection and rigidity of the full cage. I have mixed feelings about this. The car looks really good with the shorter front hoop that is just tall enough to hold the back of the hood up and the rear diagonals to the back of the car and nothing in front of the rear hoop above the upper lip of the body, making getting in and out much easier. The lip is about 21″ from the bottom of the body on the side, 27″ across the back, and 24″ at the base of the windshield where the back of the hood goes. Well technically the back of the hood is level with the base of the windshield and even with the firewall to allow hot air to exit from around the engine, but close enough for this description. The front hoop still goes in front of the firewall as before, but only goes to the bottom of the windshield instead of over my head when seated. And there will be dzus tabs welded to the top to retain the back of the hood. The hood also fits over the nose center section and under the downforce generators at the edges. This is something I have to cut and fit when I do the front end.
Something I haven’t mentioned up to this point is that the body will drop in place on the frame since there isn’t the bracing to stiffen up the hole in the frame in the way. How I plan to restore the lost stiffness from this is something I still haven’t figured out. I plan on bracing the sides and front and back to the greatest extent physically possible, but that still won’t completely make up for the loss from the hole. While typing the sentence I contemplated bracing over the cockpit with some kind of bolt-in brace that still lets me carry a passenger so the car remains Goodguy’s legal, and a second brace that doesn’t allow passenger access for the SCCA events that don’t require a usable passenger seat. I can eke out a bit more stiffness by blocking the passenger side of the car.