Life has been very uninteresting lately, it’s winter and that uncomfortable kind of cold that can’t be dressed properly for. I’m either still cold, or sweating because I have too much on, or both because the temperature can’t figure out what it wants to do. I still have to pay my property taxes now that I found out that at least one of the offices does not accept debit cards and I managed to track down my checkbook that I hardly ever use except to void a check when someone prefers to pay by direct deposit.
So I have my checks for whenever the weather improves to the point I can do the walk between the three offices on State St. in Garland. In good weather it’s a nice walk from 5th to Garland Ave, less than a mile. And there are bus stops on both ends but it is only a short walk from Downtown Garland station to the first tax office, less than a quarter of a mile.
And at some point I really need to stop at a CVS or other store that carries butane to fuel the torch that heats the bender for the plastic rod I’m using for the frame of the Mini Sprint-T. And while I’m on the subject of cars I found a really good intake manifold for a SBC to use should I wind up running a SBC on the 1:1 Sprint-T. This manifold is an evolution of the TPI GM intake from the late ’80s early ’90s, that produced prodigious low-end torque but ran out of breath above 3000 RPM partially because of the state of the art for EFI at the time. Well this version breathes all the way up top, with “top” depending on displacement but generally higher than a factory cast crank will live with. The tech person I was in chat with says for a 383 the “top” is above 6000. The tech manual advises against using E85 but the only thing I can find that might not be compatible with the fuel is possibly the fuel injectors or the rubber injection lines supplied. Those are all easy to replace with alcohol rated devices or materials. The crank and piston kit I’m looking at has a max continuous of 5200 RPM or a short-burst redline of 5500 RPM.
Finding a kit to build a 383 that runs on 87 octane NA is another problem entirely. Most of them are too high a compression ratio for 87, or built for forced induction and cost too much because they are designed for higher HP than a NA engine can make on either 87 octane or E85. Sure that makes for an engine that is unlikely to fail even during racing, but I could buy a kit not made for boost that would be just as reliable and a bunch less expensive if they would use the same parts they use for 93 octane except for the extremely dished pistons in the hyper eutectic material instead of forged used in the boost-capable kits. Locally the difference between 87 and 93 octane is $0.30-0.50/gallon, or about 20-30%, and E85 is about a penny more than 87. Depending on tune it might be cheaper to run on E85 all the time using the 93 octane kit if I wasn’t concerned with availability for long trips. But for that I have the possibility of running a storage tank in the tire trailer to extend the range enough to get between E85 stations on the Interstate when driving between races, and there are plenty of places to refuel locally.