The office temperature was 74°F (23.3°C) this morning! It was cooler than that when I went shopping for a solution to the drain plug problem we are having in the kitchen sink and redeemed a coupon for a free Avocado Bacon Burger at the local Whataburger. Then it was about the same as it is right now outside: 66°F.
Mrs. the Poet is not sure she likes the solution I found for her constantly failing drain plugs: what Lowe’s calls a “suction stopper” which is basically a round sheet of rubber that covers the drain, and a stainless mesh filter that fits inside the drain and removes for cleaning. Total cost $7 and the only failure points are eventually the rubber will age into uselessness (almost typo that would also have worked: “uselessmess”) and the mesh can be torn if a fork gets caught in it. Unlike the one we bought last year for $3 at the local grocery that has a built-in failure that is pretty much guaranteed because that’s exactly how all 3 of the last ones we bought failed, there is a barbed insert that fits through a hole in the rubber stopper, and after some use the water pressure in the full sink will overcome the tenacity of the barbed insert and the stopper gets left behind when the rest of the assembly is removed to allow drainage. This is another design defect in that the strainer has to be removed to drain the water so it doesn’t actually strain the debris from going down the drain. The new plug and strainer doesn’t have this failing.
I’m still thinking (Danger Will Robinson!) about the Sprint-T design, this time about the lateral location device for the rear axle. With the various types and sizes of tires I will be using some adjustability in the rear suspension to change the balance of grip front to rear. Looking at the many ways to get this adjustability the simplest way is adjusting the rear roll center height by moving the vertical attachment of the rear lateral location device. Well, I did the bending stress on a 1.125″ fine thread bolt and for the LS and lighter engines this will be just big enough to not fail in long term use. There might be some flex while racing, and it is a definite failure point if I bang a curb with the right rear tire on the street, but the flex will not be noticeable to the driver and I’m not supposed to be banging curbs anyway. Construction will be super easy: After I cut the pivoting piece for the Watt’s link I cut a 1.125″ hole in the center for the pivot bolt then weld a fine thread nut with a grease fitting over the hole and machine out a bit of the arm to clear the bolt in use. I don’t know how much adjustment I will actually need and I could probably rebuild the mount for the pivot arm with only as much bolt as I need left unsupported from flex after I finish testing. Then I could just machine away the rest of the bolt past the support structure and save that little bit of weight.
Speaking of saving weight, I’m having some issues with how to attach the bracket for the Watt’s link to the rear axle housing, mostly because I still haven’t settled on which rear axle to use, the nine-inch Ford with an aluminum center section and a fabricated aluminum housing and axle tubes or the Winters V8 quick change with a magnesium center section and aluminum side bells with aluminum axle tubes. The generic Nine Inch would be a touch cheaper and has more clearance at droop, while the V8 is slightly lighter and has a better selection of final drive ratios. That availability of final drive ratios might be the thing that swings the decision. Anyway, the Nine Inch housing will have to have a mount welded on the back, while the V8 can have the bracket bolted with longer studs on the side bell, making modification a simple matter of unbolting the test bracket and bolting on the permanent bracket, another point in favor of the V8 QC axle.
And this once again points out that designing a car from scratch is a good thing to do for us old people with ADD because there are so many sub-systems that have to be hashed out so progress can still be maintained when interest fades on whatever I’m working on at the moment.